Table of Contents
Advertisement
10. How to Use the PJ Controller
E-mail Setting
The projector has a function to send an e-mail to inform its operating condition to the
administrator or users. Select E-mail Setting from the main menu and configure each item as
follows:
1. Registering E-mail Address
Parameter
SMTP Server ..................................Enter the address of SMTP server and click "Set".
Administrator Address ....................Enter the E-mail address of administrator and click "Set".
Mail Address ..................................Enter E-mail addresses of users and click "Set".
Option ......................................When the checked item has occurred, the projector sends alert
✳
The SMTP server is a server for sending E-mail. Please contact your network administrator to have this
SMTP server address.
✳
To use the E-mail function, the DNS address must be set correctly. (Refer to "6. Configurations with
➔
Browser"
You cannot use this E-mail function if the SMTP server is not available in your network environment. If
the SMTP server is located in your LAN (Local Area Network), the address set to SMTP server should be
specified the in SMTP server located in your LAN. The server located outside of your LAN may not be
available for security reason. For further information, please contact your network administrator.
76
Description
To delete the E-mail address, click "Delete".
messages.
➔
"Advanced Setup"
"TCP/IP" (p.46).)
Advertisement
Table of Contents
