Watchguard Firebox X20E Reference Manual page 49

Making a backup of the current configuration file
To ensure that you always have a backup version of a current, working configuration
file, copy the configuration file stored in the primary area to the Firebox flash disk
backup area. From the Control Center:
1 Select LiveSecurity Desktop => Tools => Advanced => Flash Disk Management.
2 Select Make Backup of Current Image. Click Continue.
A verification prompt appears. Verify that the Management Station connects to the Firebox
Trusted interface either over the network (TCP/IP) or via a modem using out-of-band
management.
3 Click Yes.
The Connect To Firebox dialog box appears.
4 Use the Firebox drop list to select a Firebox or type the IP address used by the
Management Station to communicate with the Firebox. Enter the configuration
(read/write) passphrase. Click OK.
When the backup is successful, an Operation Complete alert appears.
5 Click OK.
You do not need to reboot the Firebox.
Restoring a backup configuration file
Backing up and restoring a configuration file acts not only on the configuration file
but on the enture flash image. This is important to note if you are loading a new
version, patch, or component onto the Firebox.
Restore the backup configuration file to the primary area of the Firebox flash disk
when:
• You incorrectly overwrite the primary configuration file.
• The primary configuration file is incorrectly configured or is otherwise
unusable.
1 Select LiveSecurity Desktop => Tools => Advanced => Flash Disk Management.
The Flash Disk Management Tool dialog box appears.
2 Select Restore Backup Image. Click Continue.
A verification prompt appears. Verify that the Management Station connects to the Firebox
Trusted interface either over the network (TCP/IP) or via a modem using out-of-band
management.
3 Click Yes.
The Connect To Firebox dialog box appears.
4 Use the Firebox drop list to select a Firebox or type the IP address used by the
Management Station to communicate with the Firebox. Enter the configuration
(read/write) passphrase. Click OK.
The Firebox copies the configuration file from the backup area to the primary area of its flash
disk and reboots from the backup configuration file.
Reference Guide
This procedure is only possible when a backup configuration
file is on the backup area of the Firebox's flash disk. See
"Making a backup of the current configuration file" on
page 45. There is no backup file on the Firebox until you copy
one there.
Managing flash disk memory
45