Roland Session SR-JV80-09 Owner's Manual

Thank you for choosing the Roland SR-JV80-09 "Session" Wave
Expansion Board.
This expansion board provides grand pianos sampled in stereo,
high-quality strings, choirs, nylon guitars, powerful wind instruments,
and electric guitars — as well as Waveforms, Patches and Rhythm
Sets that include stacked synth sounds.
Thanks to the enormous wealth of high-quality sounds contained in
the SR-JV80-09 Expansion Board, you can greatly enhance your
performances, and cover a much larger variety of musical genres.
Waveforms: 206 Kinds
Patches
255 kinds designed for the JV-1010/1080/2080 & XP series;
another 200 for the JV-80/880/90/1000.
(On the JD-990, you can use Patches designed to be used with
the JV-80/880/90/1000 if you "Convert Load" them first.)
Rhythm Sets
8 kinds designed for the JV-1010/1080/2080 & XP series; another
2 for the JV-90/1000.
The Rhythm Sets in this expansion board cannot be used with the
JV-80/880 or JD-990.

INSTALLING THE EXPANSION BOARD

Turn off your instrument.
*
1. Remove the cover located on the bottom (or top) of your instrument.
2. Check that the plastic board holders are positioned as shown. Rotate
them if necessary.
3. While positioning the holes on the board over the board holders,
carefully insert the connector on the board into the socket on the
instrument. Make sure the connector is securely connected, and that
all three board holders project through the holes.
* Do not touch any of the printed circuit pathways or connection
terminals.
* Never use excessive force when installing a Expansion Board. If it
doesn't fit properly on the first attempt, remove the board and try again.
4. Use the supplied Installation Tool to turn the holders in the LOCK
direction, so the board will be fastened in place.
(To remove the Expansion Board, turn the board holders in the
UNLOCK direction, and lift up the board using the provided tool.
Remove the board and secure the cover plate.)
* When Expansion Board installation is complete, double-check your
work.
5. Check if the Expansion Board is correctly installed.
If the "EXP" display cannot be selected (doesn't appear) in the Waveform
Selection Screen (refer to the owner's manual of the instrument you use),
remove the Expansion Board and install it properly.
1
Screwdriver
2 3
Board holder
Board holder
Before using this unit, carefully read the sections entitled: "USING THE
UNIT SAFELY" and "IMPORTANT NOTES" These sections provide
important information concerning the proper operation of the unit.
Additionally, in order to feel assured that you have gained a good grasp
of every feature provided by your new unit, this manual should be read
in its entirety. The manual should be saved and kept on hand as a
convenient reference.
1.
2.
3.
4.
5.
4
Connector
Expansion board removal
LOCK