Installing Or Replacing A Memory Module - Lenovo ThinkCentre A63 6674 Hardware Maintenance Manual

To remove and reinstall the front bezel, do the following:
1. Remove the computer cover. See "Removing the computer cover" on page 85.
2. Release the three plastic tabs on the left side of the front bezel and pivot the
Figure 6. Removing the front bezel
3. To reinstall the front bezel, align the plastic tabs on the right side of the front
4. To complete the installation, go to "Completing the FRU replacement" on page

Installing or replacing a memory module

This section provides instructions on how to install or replace a memory module.
Your computer has two slots for installing or replacing DDR3 DIMMs that provide
up to a maximum of 4 GB system memory. When installing or replacing a memory
module, use 1 GB or 2 GB DDR3 DIMMs in any combination up to a maximum of
4 GB.
To install or replace a memory module, do the following:
1. Remove the computer cover. See "Removing the computer cover" on page 85.
2. Remove any parts that might prevent your access to the memory slots.
front bezel outward to remove it.
bezel with the corresponding holes in the chassis, then pivot the front bezel
inward until it snaps into position on the left side.
116.
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
Chapter 8. Replacing FRUs
89