System Board System Board; Flash The System. See "Updating (Flashing) Bios From A Disc; Make Sure The Component That Is Called; Out Is Connected And/Or Enabled. See - Lenovo ThinkCentre A63 6674 Hardware Maintenance Manual

Diagnostic error code
015-000-XXX
USB (Universal Serial Bus) port Interface
Test Passed
015-001-XXX
USB port Presence
015-002-XXX
USB port Timeout
015-015-XXX
USB port External Loopback failure
015-027-XXX
USB port Configuration/Setup error
015-032-XXX
USB port Device Controller failure
015-034-XXX
USB port buffer
allocation failure
015-035-XXX
USB port Reset condition detected
015-036-XXX
USB port Register error
015-040-XXX
USB port IRQ failure
015-195-XXX
USB port Test aborted by user
015-196-XXX
USB port test halt, error threshold exceeded
015-197-XXX
USB port test warning
FRU/Action
No action
1. Remove USB device(s) and re-test
2. System board
1. Remove USB device(s) and re-test
2. System board
1. Remove USB device(s) and re-test
2. System board
1. Flash the system. See "Updating
(flashing) BIOS from a disc" on page
170
2. System board
System board
1. Reboot the system
2. Flash the system and re-test. See
"Updating (flashing) BIOS from a disc"
on page 170
3. Run memory test
4. System board
1. Remove USB device(s) and re-test
2. System board
System board
1. Run setup and check for conflicts
2. Flash the system. See "Updating
(flashing) BIOS from a disc" on page 170
3. System board
Information only
Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file

1. Make sure the component that is called

out is connected and/or enabled. See

Chapter 6, "Using the Setup Utility," on

page 51

2. Re-run test

3. Replace the component that is called out

in warning statement

4. Replace the component under test
Chapter 7. Symptom-to-FRU index
65