Advertisement
Quick Links
4-448-230-01(1)
/
Electronic Viewfinder Kit/
Kit pour viseur électronique/
/Operating Instructions/Mode d'emploi/
Manual de instrucciones/
FDA-EV1MK
© 2012 Sony Corporation Printed in Japan
1
2
7
3
6
5
4
ˎ
ˎ
ˎ
WEB
1 FINDER/LCD
2
3
4
5
6
7
OFF
ˎ
ˎ
ˎ
ON
ˎ
ˎ
ˎ
FINDER/LCD
ˎ
FINDER/LCD
ˎ
ˎ
ˎ
ˎ
ˎ
ˎ
ˎ
ˎ
ˎ
99.99%
ˎ
ˎ
ˎ
ˎ
ˎ
ˎ
ˎ
ˎ
ˎ
ˎ
ˎ
26.2 mm 30.75 mm
40.4 mm
45.4 mm 41.54 mm
53.0 mm
26.6 g
31.2 g
EL
1.3 cm 0.5
2 359 296
100
1.09
50mm
-1m
-1
23 mm
21 mm
-1m
-1
-4.0 m
-1
+1.0 m
-1
1
1
1
1
1
1
ˎ
ˎ
1
ˎ
7
ˎ
FDA-EV1MK
ˎ
ˎ
For the customers in the U.S.A.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation.
CAUTION
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority
to operate this equipment.
NOTE:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or
more of the following measures:
ˋ
ˋ
Reorient or relocate the receiving antenna.
ˋ
ˋ
Increase the separation between the equipment and
receiver.
ˋ
ˋ
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
ˋ
ˋ
Consult the dealer or an experienced radio/TV technician
for help.
For the customers in Canada
This Class B digital apparatus complies with Canadian ICES-
003.
This unit can be used with a Sony Digital Still Camera
(referred to below as "camera") with a Multi Interface Shoe.
For details on compatible camera models of this unit, visit the
Sony website in your area, or consult your Sony dealer or local
authorized Sony service facility.
These cameras are not available in all countries/regions.
WARNING
Keep out of reach of small children to prevent accidental
swallowing.
To reduce fire or shock hazard, do not expose the unit to rain
or moisture.
CAUTION
To avoid injury, be careful not to drop this unit.
Careless handling can lead to injury.
Identifying the Parts
1 FINDER/LCD button
2 Eyepiece lens
3 Soft eyepiece cup
4 Eyepiece sensors
5 Diopter-adjustment lever
6 Connector protect cap
7 Eyepiece cup
Before using this unit
You can replace the soft eyepiece cup with the supplied
eyepiece cup according to your preference.
To remove the eyepiece cup, grip the bottom on both
sides and pull it off. (See illustration )
To attach the eyepiece cup, press it until it clicks into
place.
Attaching this Unit
Before attaching this unit
ˎ
Set the power of the camera to OFF.
ˎ
Remove the connector protect cap from this unit.
To attach this unit
Turn off the power of the camera. Firmly insert this unit
all the way into the Multi Interface Shoe of the camera in
the direction shown.
To detach this unit
Turn off the power of the camera and then detach this
unit by following the attaching procedure in reverse.
Using this unit
ˎ
Set the power of the camera to ON.
ˎ
Look into this unit and adjust the diopter-adjustment lever
till the display appears clearly in this unit.
ˎ
When you look into this unit, the image is displayed in this
unit due to the action of the eyepiece sensors. When you
move your face from this unit, the image display returns to
the LCD monitor of the camera.
ˎ
Press the FINDER/LCD button of this unit to switch the
display between this unit and the LCD monitor on the
camera.
ˎ
Depending on the status of use, the eyepiece sensors may be
activated so no images appear on the LCD monitor of the
camera. If this happens, press the FINDER/LCD button of
this unit.
Notes on Use
ˎ
Do not touch the eyepiece lens or connector of this unit.
ˎ
You cannot use this unit together with an external flash or
other device attached to the camera by the Multi Interface
Shoe.
ˎ
Be careful not to subject this unit to mechanical shock
while attaching it.
ˎ
Do not hold the camera only by this unit.
ˎ
When carrying this unit, remove it from the camera
first. When carrying this unit, attach the connector
protect cap to this unit. Then put it in the supplied
carrying case. (See illustration )
ˎ
If you wear glasses and have difficulty in viewing in this
unit, you can remove the eyepiece cup from this unit.
ˎ
The display on the LCD monitor of the camera may differ
from the display in this unit because of the difference of
their display sizes.
ˎ
For details about the screen indicator of this unit and how
to set it with a camera, refer to the Instruction Manual of
your camera.
ˎ
You can change the angle of this unit depending on the
situation of use.
ˎ
The LCD monitor and electronic viewfinder are
manufactured using extremely high-precision technology
so over 99.99% of the pixels are operational for effective use.
However, there may be some tiny black points and/or bright
points (white, red, blue or green in color) that constantly
appear on the LCD monitor and electronic viewfinder.
These points are normal in the manufacturing process and
do not affect the images in any way.
ˎ
Do not keep the eyepiece lens pointed toward the sun or
other bright light source.
ˎ
This unit may become warm after extended use. This is not
a malfunction.
ˎ
Depending on the surrounding lighting conditions or scene,
the movement of the subject may be jerky, or flickering or
moiré patterns may appear in this unit. These do not affect
the recorded image in any way.
ˎ
Do not disassemble this unit or its performance
cannot be guaranteed.
ˎ
When using this unit outside, be careful not to get it wet
with rain or seawater.
ˎ
Do not leave this unit in direct sunlight, in a closed car or
near a heater.
ˎ
Do not swing the case by the attached strap etc. The case
may detach from the strap or this unit may fly out of the
case.
ˎ
Keep the magnetic snap of the carrying case away from
floppy diskettes and other items that are affected by
magnetism.
Cleaning this unit
ˎ
Wipe off any dust from the surface of this unit lightly with a
soft clean cloth.
ˎ
Brush off any dust from the eyepiece lens with a blower
brush and wipe it lightly with the supplied cleaning cloth.
Specifications
26.2 mm × 30.75 mm × 40.4 mm
Dimensions (Approx.)
(1.03 in. × 1.21 in. × 1.59 in.)
(w/h/d)
(excluding the eyepiece cup and
projecting parts)
45.4 mm × 41.54 mm × 53.0 mm
(1.79 in. × 1.64 in. × 2.09 in.)
(with the soft eyepiece cup attached)
Mass
Approx. 26.6 g (0.9 oz.)
(excluding the eyepiece cup)
Approx. 31.2 g (1.1 oz.)
(with the soft eyepiece cup attached)
Electronic viewfinder
Type
(Organic Electro-Luminescence)
Screen size
1.3 cm (0.5 type)
Total number of dots 2 359 296 dots
Frame coverage
Approx. 100%
Magnification
1.09 × with 50 mm lens at infinity,
–1 m
–1
(diopter)
Eye Point
Approximately 23 mm from the
eyepiece, 21 mm from the eyepiece
frame at –1 m
–1
Dioptor Adjustment
–4.0 m
–1
to +1.0 m
–1
(diopter)
Included items
Electronic viewfinder (1), Soft eyepiece cup (1), Eyepiece cup
(1), Connector protect cap (1), Carrying case (1), Cleaning
cloth (1), Set of printed documentation
Design and specifications are subject to change without notice.
"Multi Interface Shoe" is a trademark of Sony Corporation.
À l'intention des clients aux É.-U.
Cet appareil est conforme à la Partie 15 de la réglementation
de la FCC des États-Unis. Son utilisation est sujette aux deux
conditions suivantes :
(1) Cet appareil ne doit pas générer d'interférences nuisibles et
(2) il doit être en mesure d'accepter toute interférence reçue, y
compris les interférences pouvant générer un fonctionnement
indésirable.
AVERTISSEMENT
Par la présente, vous êtes avisé du fait que tout changement
ou toute modification ne faisant pas l' o bjet d'une autorisation
expresse dans le présent manuel pourrait annuler votre droit
d'utiliser l'appareil.
REMARQUE:
L'appareil a été testé et est conforme aux exigences d'un
appareil numérique de Classe B, conformément à la Partie 15
de la réglementation de la FCC.
Ces critères sont conçus pour fournir une protection
raisonnable contre les interférences nuisibles dans un
environnement résidentiel. L'appareil génère, utilise et peut
émettre des fréquences radio; s'il n' e st pas installé et utilisé
conformément aux instructions, il pourrait provoquer des
interférences nuisibles aux communications radio.
Cependant, il n' e st pas possible de garantir que des
interférences ne seront pas provoquées dans certaines
conditions particulières. Si l'appareil devait provoquer des
interférences nuisibles à la réception radio ou à la télévision,
ce qui peut être démontré en allumant et éteignant l'appareil,
il est recommandé à l'utilisateur d' e ssayer de corriger cette
situation par l'une ou l'autre des mesures suivantes :
ˋ
ˋ
Réorienter ou déplacer l'antenne réceptrice.
ˋ
ˋ
Augmenter la distance entre l'appareil et le récepteur.
ˋ
ˋ
Brancher l'appareil dans une prise ou sur un circuit différent
de celui sur lequel le récepteur est branché.
ˋ
ˋ
Consulter le détaillant ou un technicien expérimenté en
radio/téléviseurs.
Pour les clients au Canada
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada.
Cet article peut être utilisé avec un appareil photo numérique
Sony (appelé ci-dessous « l'appareil photo ») à griffe multi-
interface.
Pour le détail sur les modèles d'appareils photo compatibles
avec cet accessoire, consultez le site Sony de votre région, ou
adressez-vous à votre revendeur Sony ou à un service après-
vente agréé Sony.
(Suite à la page arrière)
Advertisement
