Specifications; Wall-Mounting Your Tv - Insignia NS-LCD32-09CA User Manual

Insignia NS-LCD32-09CA 32" LCD TV 720p
Symptom Possible solution
Poor picture
Horizontal dotted line
"Ghost" or double image
Picture has a few bright
or dark dots
Remote control does not
work
Snowy picture or noise
VGA picture is not stable
or synchronized
No output from one of
the speakers
Control buttons do not
work
After images appear

Wall-mounting your TV

Wall-mount hardware (sold separately) lets you
mount your TV on a wall. For detailed
information on mounting your TV on a wall, see
the instructions provided with the wall-mount
hardware.
Contact a technician for assistance when
installing the wall-mount bracket. Best Buy is not
responsible for any damage to your TV or injury
to yourself or others.
• Make sure that the room is not
too bright. Light reflecting off
the screen can make the picture
difficult to see.
• If an S-VHS camera or a
camcorder is connected while
another connected device is
turned on, the picture may be
poor. Turn off one or more
devices.
• Your TV may be too close to
another electrical device, such
as a hair dryer or neon light.
Turn off the device or move
your TV.
• This may be caused by
obstructions to the antenna,
such as high-rise buildings or
hills. Using a highly directional
antenna may improve the
picture quality.
• A few bright or dark dots on an
LCD screen is normal. It does
not affect the operation of this
TV.
• Press TV.
• Replace the batteries. Make
sure that the + and – symbols
on the batteries align with the +
and – symbols in the battery
compartment.
• Clean the remote sensor on the
front of your TV.
• Bright or fluorescent lighting
may interfere with the remote
control signal. Turn off the light
or move your TV.
• Make sure that the A/V and
antenna cables are connected
correctly and securely.
• Make sure that you have
selected the correct VGA mode
on your computer.
• Adjust the balance in the Sound
menu.
• Unplug the power cord, wait a
few seconds, then plug the cord
back in and turn on your TV.
• Do not display a still image,
such as a logo, game, or
computer image, for an
extended period of time. This
can cause a permanent after
image to be burned into the
screen. This type of damage is
not covered by your warranty.
www.insignia-products.com
We suggest that you keep your TV at least
2.36 inches (60 mm) from the wall to prevent
cable interference.
To attach a wall-mount bracket to your TV:
1 Remove the two T4 and two M4 screws
holding your TV to the stand.
Remove T4
screws
2 Remove the four screws from the bottom of
the stand.
Remove four stand screws
3 Secure the wall-mount bracket to the back of
your TV using four M6 screws as indicated in
the illustration in Step 1.

Specifications

Design and specifications are subject to change
without notice.
Analog standard NTSC
Screen 32-inch
Channel coverage VHF: 2-13
UHF: 14-69
CATV: Mid band - A-8 ~ A-1, A ~ I
Super band - J ~ W
Hyper band - AA ~ ZZ, AAA, BBB
Ultra band - 65 ~ 94, 100 ~ 135
Power source AC 100~240 V 50/60 Hz
Power consumption <200 W
<1 W in standby mode
Audio power 5 W + 5 W internal speaker
S-Video input Y: 1 V(p-p), 75 ohm, negative sync
C: 0.286 V(p-p) (burst signal), 75 ohm
Video/audio input Video: 1 V(p-p), 75 ohm, negative sync
Audio: 500 mV(rms)
7.88 inches
(20 cm)
Attach
bracket
here
Remove M4
screws
Remove stand
17