Power-Up Sequence; Transmission Sequence For Instructions - IEE 03875-21-0214 Reference Manual

3.3 Power–up Sequence
Upon power–up, the serial Daystar Nova display module is automatically initialized to the format defined by the
jumper settings and default values shown in Figure 6. The power–up sequence takes about 0.5 second.
3.4

Transmission Sequence for Instructions

Figures 7 and 8 depict the recommended sequence for each data or instruction transmission.
Industrial Electronic Engineers, Inc.
Van Nuys, California
Baud rate:
Parity bit present:
Parity checking enable:
Parity (Odd or Even):
7 or 8 data bits
Multiplex rate of LCD:
Display clear:
Display ON/OFF:
Cursor location:
Cursor:
Entry mode set:
Controller:
Data/Instructions:
Figure 6 Default Configuration at Power–up
11h
Byte 1 2
Figure 7
12h
Byte 1 2
Figure 8
Jumper defined (per section 4.2)
"
"
"
"
"
YES
ON
Position 0
OFF
Shift cursor right after character entry
1
Data
3 4
Instruction Sequence
3 4
Data Sequence
SIZE CODE IDENT NO.
A 05464
SCALE N/A REV A
n
n
S03875–21–0214
SHEET 11