Humminbird AS RSL Operation Manual page 9

WSL Accessory Submenu
When the WSL Accessory is attached to the control head, the Accessory menu tab in the Main Menu System will contain
an additional SmartCast WSL menu choice which, when selected, leads to the SmartCast WSL Accessory Submenu.
Press the MENU key twice to access the Main Menu tab choices. Use the 4-Way Cursor Control key to select the Accessory
tab, and then scroll down to select the SmartCast WSL menu choice - use the RIGHT Cursor Control key to enter the WSL
Accessory Submenu.
Accessory Menu:
WSL Accessory Submenu
with Wireless Sonar
Link added
PIP (Picture in Picture) Setting - This menu choice sets whether the PIP view is Off, On or set to Auto.
When set to O O f f f f , the PIP View is not available in the view rotation.
When set to O O n n , the PIP View will be superimposed on all views (with the exception of the full screen WSL View) the first
time that the RSS is cast into the water. When the RSS is out of the water or if the signal reception is being blocked, the
message "SmartCast WSL signal not detected" will appear. The PIP View can be removed from the view rotation by press-
ing the EXIT key. The next time the RSS enters the water, the PIP View will be displayed again.
When set to A A u u t t o o , the PIP View will be superimposed on all views (with the exception of the full screen WSL view) the first
time that the RSS is cast into the water. When the RSS is out of the water or if the signal reception is being blocked, the
message "SmartCast WSL signal not detected" will flash on the PIP View and the PIP View will then be removed automat-
ically from the view rotation. The next time you cast the RSS back into the water, or if signal reception is regained, the PIP
View will be displayed automatically. (Off, On, Auto, Default = Off)
Channel Select: This menu choice should be set to A for the Channel A RSS that is shipped with your WSL Accessory. If you
buy a replacement RSS that is hard-wired as a Channel B, then you must change this setting to B. Select either A or B to
match your RSS. See Channel A and B RSS Units. (Channel A or Channel B, Default = Channel A)