Dc Adaptor - VTech SkillStarter Handheld User Manual

NOTE: The use of new, alkaline batteries is recommended for maximum
performance.
IMPORTANT!!!
When replacing the 3 "AAA" size batteries, make sure the backup battery is in
place or the SkillStarter™ Handheld is plugged into the wall outlet with a 9V
adaptor. Otherwise, you will lose all the information stored in certain applications.
Standard for battery toys
• Do not try to recharge non-rechargeable batteries;
• Rechargeable batteries are to be removed from the toy before being charged;
• Rechargeable batteries are only to be charged under adult supervision;
• Do not mix different types of batteries; Do not mix new and used batteries;
• Only use batteries of the recommended or equivalent type;
• Always insert batteries properly matching the plus (+) and minus (-) signs;
• Batteries that have run out of energy must be removed from the toy;
• Do not short circuit the supply terminals;
• Do not use more batteries than recommended;
• Remove batteries from toy if it will not be used for an extended period of
time.
NOTE: If the unit suddenly stops working or the sound becomes weak, turn
the unit OFF for 15 seconds, then turn it back ON. If the problem
persists, it may be caused by weak batteries. Please install a new set
of batteries and try again.

DC ADAPTOR

Use VTech® or any standard adaptor complying with EN61558 DC 9V
DC center-positive adaptor.
Connection:
1. Make sure the unit is OFF.
2. Locate the adaptor jack on the back of the keyboard docking.
3. Insert the adaptor plug into the unit's adaptor jack.
4. Plug the adaptor into a wall outlet.
5. Turn the unit ON.
NOTE: If the unit suddenly stops working or the sound seems weak, it may be
the result of the adaptor connection. Turn the unit OFF and unplug the
3
300mA