Table of Contents
Advertisement
Available languages
Available languages
English
MAINTENANCE AND INSPECTION
WARNING:
1. Inspecting the socket
A worn or deformed hex. or a square-holed socket will not give an adequate
tightness to the fitting between the nut or anvil, consequently resulting in loss of
tightening torque. Pay attention to wear of socket holes periodically, and replace
with a new one if needed.
2. Inspecting the screws
Regularly inspect all screws and ensure that they are properly tightened. Should
any of the screws be loosened, retighten them immediately.
WARNING:
3. Maintenance of the motor
The motor unit winding is the very "heart" of the power tool. Exercise due care
to ensure the winding does not become damaged and/or wet with oil or water.
4. Inspecting the carbon brushes
For your continued safety and electrical shock protection, carbon brush inspection
and replacement on this tool should ONLY be performed by a HITACHI
AUTHORIZED SERVICE CENTER.
5. Service and repairs
All quality power tools will eventually require servicing or replacement of parts
because of wear from normal use. To assure that only authorized replacement
parts will be used, all service and repairs must be performed by a HITACHI
AUTHORIZED SERVICE CENTER, ONLY.
6. Service parts list
A:
Item No.
B:
Code No.
C:
No. Used
D:
Remarks
CAUTION: Repair, modification and inspection of Hitachi Power Tools must be
carried out by a Hitachi Authorized Service Center.
This Parts List will be helpful if presented with the tool to the Hitachi
Authorized Service Center when requesting repair or other
maintenance. In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each country must
be observed.
14
Be sure to switch power OFF and disconnect the plug from the
receptacle during maintenance and inspection.
Using this impact wrench with loosen screws is extremely
dangerous.
Advertisement
Table of Contents
