How To Use - Hitachi WR16SA - 4.2 Amp Electric Impact Wrench Safety And Instruction Manual

7. Mounting the socket (Fig.2)
Align the plunger located in the square
part of the anvil with the hole in the hex.
socket. Then push the plunger, and
mount the hex. socket on the anvil.
Check that the plunger is fully engaged
in the hole. When removing the socket,
reverse the sequence.

HOW TO USE

1. Operation of switch (Fig.3)
The switch in this machine functions
as a motor switch and rotational direc-
tion selector switch. When the switch
is set to R indicated on the handle
cover, the motor rotates clockwise to
tighten the bolt. When the switch is set
to L, the motor rotates counterclock-
wise to loosen the bolt. When the
switch is released, the motor stops.
CAUTION:
Be sure to turn the switch OFF and wait until the motor completely stops be-
fore changing the direction of wrench revolution. Switching while the motor is
rotating will result in burning the motor.
2. Tightening and loosening bolts
A hex. socket matching the bolt or nut must first be selected. Then mount the
socket on the anvil, and grip the nut to be tightened with the hex. socket. Hold-
ing the wrench in line with the bolt, press the power switch to impact the nut for
several seconds. If the nut is only loosely fitted to the bolt, the bolt may turn with
the nut, therefore preventing proper tightening. In this case, stop impact on the
nut and hold the bolt head with a wrench before restarting impact, or manually
tighten the bolt and nut to prevent them slipping.
Plunger
Hole
Hex. socket
Fig. 2
Switch
Fig. 3
English
Anvil
11