Sony VPL-FX30 Operating Instructions Manual page 32

4
Insert the new lamp all the way in until
it is securely in place. Tighten the
three screws.
5
Close the rear panel and tighten the
three screws.
Note
Be sure to install the lamp and rear panel
securely as it was. If not, the projector
cannot be turned on.
6
Connect the AC power cord to a wall
outlet and turn on the projector.
7
Reset the lamp timer for
the next replacement time.
Select "Lamp Timer Reset" on the
Function menu then press the ENTER
key. When a message appears, select
"Yes" to reset the lamp timer.
Disposal of the used lamp
For the customers in the USA
Lamp in this product contains mercury.
Disposal of these materials may be regulated
due to environmental considerations. For
disposal or recycling information, please
contact your local authorities or the
Telecommunications Industry Association
(www.eiae.org).
32
Replacing the Lamp
New lamp
grab
Screws
notification of