Advertisement
Quick Links
CHIMES
CH-500
CHIMES STAND
CHS-520 / CHS-506
/ Owner's Manual
Thank you for selecting the YAMAHA chimes.
Please read this owner's manual carefully, and truly enjoy this instrument for
years to come.
CH-500
CHS-506
Make sure to read the "PRECAUTIONS" on page 4 and the "Before you use" on page 5.
Advertisement
Related Manuals for Yamaha CH-500
Summary of Contents for Yamaha CH-500
- Page 1 CHIMES CH-500 CHIMES STAND CHS-520 / CHS-506 / Owner’s Manual Thank you for selecting the YAMAHA chimes. Please read this owner’s manual carefully, and truly enjoy this instrument for years to come. CH-500 CHS-506 Make sure to read the “PRECAUTIONS” on page 4 and the “Before you use” on page 5.
- Page 3 Never run. Doing so can result in the chimes running out of control and hitting an obstacle or wall causing serious injury. • The weight of the CH-500 is approximately 84kg. If the chimes must be lifted when being When lifting moved, lift them carefully, using as many persons as possible to avoid injury.
-
Page 4: Before You Use
Before you use 1 Never use a metal type hammer or mallets to strike the sound column with. The sound column will break. 2 Always use the instrument on a flat, level sur- face. The instrument will not function properly on a sloped surface. -
Page 5: Assembly Procedure
CH-500/CHS-520 ASSEMBLY PROCEDURE Insert the side columns into the base. At this time, Fit the damper onto the side columns and lower make sure that the damper rest, attached at the the damper onto the damper rest. Next, secure center of the column, and the short section of the the damper in its position with the damper wing column is positioned upright. - Page 6 CH-500/CHS-520 ASSEMBLY PROCEDURE Slide the hanger onto the side columns. Before hanging the sound columns on the hanger, activate the damper stopper. Position the sound column with its pitch inscription Hanger facing forward, place one side of the wire/strings into the slot of the fixing pin. Next, hook the wire/...
- Page 7 CHS-506 ASSEMBLY PROCEDURE Fit the guide board onto the side columns and lower the guide board until it rests on the board rest. With the fixing hole on the base bar aligned with the bolt hole in the base, connect the base bar to the base.