Serial Ata Hard Disk Drive Connection - Asus M3A - Motherboard - ATX User Manual

3. AMD SB600 Southbridge Serial ATA connectors
®
(7-pin SATA1 [red]; SATA2 [black]; SATA3 [red]; SATA4 [black])
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
and optical disk drives.
If you install SATA hard disk drives to the SATA1/2/3/4 connectors, you can
create a RAID 0, RAID 1, or RAID 0+1 configuration through the onboard
AMD SB600 controller.
®
®
M3A SATA connectors

Serial ATA hard disk drive connection

Connector
SATA 1/3
SATA 2/4
• These connectors are set to [Native IDE] by default. If you intend to create
a Serial ATA RAID set using these connectors, set the Onchip SATA Type
item in the BIOS to [RAID]. See section 4.4.3 Chipset for details.
• Before creating a RAID set, refer to 5.4.2 RAID Configuration or the
manual bundled in the motherboard support CD.
• You must install the Windows
hard disk drives. The Serial ATA RAID feature (RAID 0 and RAID 1) is
available only if you are using Windows
• When using the connectors in Native IDE mode, connect the primary (boot)
hard disk drive to the SATA1/2/3/4 connector. Refer to the table below for
the recommended SATA hard disk drive connections.
Connect the right-angle side
of SATA signal cable to SATA
device. Or you may connect the
right-angle side of SATA cable to
the onboard SATA port to avoid
mechanical conflict with huge
graphics cards.
ASUS M3A
SATA1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
SATA4
GND
RSATA_TXP4
RSATA_TXN4
GND
RSATA_RXP4
RSATA_RXN4
GND
Color
Red
Black
XP Service Pack 1 before using Serial ATA
®
SATA3
GND
RSATA_TXP3
RSATA_TXN3
GND
RSATA_RXP3
RSATA_RXN3
GND
SATA2
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND
Setting
Master
Slave
XP or later version.
®
right angle side
Use
Boot disk
Data disk
2-25