Asus M2N32-SLI Premium VISTA Edition User Manual page 56

4. Silicon Image
This connector is for a Serial ATA signal cable. This connector supports
a Serial ATA hard disk drive that you can configure for RAID through the
onboard Serial ATA RAID controller.
M2N32-SLI PREMIUM
SATA RAID connector
M2N32-SLI PREMIUM
M2N32-SLI PREMIUM
SATA RAID connector
2-28
Connect the right-angle side
of SATA signal cable to SATA
device. Or you may connect the
right-angle side of SATA cable to
the onboard SATA port to avoid
mechanical conflict with huge
graphics cards.
Serial ATA RAID connector (7-pin SATA_RAID2)
®
The Silicon 3132 Controller item in the BIOS is set to [SATA Mode] by default,
allowing you to enable the hot-plug function for the external device. Set to [RAID
Mode] to use the connectors to build a RAID set. See section 4.4.6 Onboard
Device Configuration for details.
M2N32-SLI PREMIUM
Before creating a RAID set using Serial ATA hard disks, make sure that you
have connected the Serial ATA signal cables and installed Serial ATA hard disk
drives; otherwise, you cannot enter the Silicon Image
BIOS setup during POST.
right angle side
SATA_RAID2
SATA_RAID2
GND
RSATA_RXP5
RSATA_RXP5
GND
GND
RSATA_TXN5
RSATA_TXP5
RSATA_RXP5
GND
RSATA_RXP5
GND
RSATA_TXN5
RSATA_TXP5
GND
RAID utility and SATA
®
Chapter 2: Hardware information