9.6 Connecting to Car Kit Phones
Bluetooth car kit phones that support the SIM Access Profile (SAP) can connect to
your phone and access its SIM card via Bluetooth. Once a SAP connection has been
established, you can download device and/or SIM contacts from your phone to the
car kit phone, and use the car kit phone to answer and make calls.
1.
On the Home screen, slide to the Settings tab, tap Communications, and
then tap Bluetooth.
2.
Turn Bluetooth on and set your phone to visible mode. For instructions, see
"To turn Bluetooth on and make your phone visible" earlier in this chapter.
3.
On the Settings tab (
4.
Scroll down and tap SIM Access.
5.
Select the Enable SIM Access Profile (SAP) check box, and then tap Done.
6.
Connect the car kit phone to your phone via Bluetooth. For instructions, refer
to your car kit phone's manual.
7.
If this is the first time you are pairing the car kit phone with your phone, enter
the car kit phone's passcode on your phone.
8.
A pop-up message should appear on your phone saying that a connection
has been established between your phone and car kit phone. Tap OK.
Note
You are not able to make and receive calls, send and receive messages, or perform
related activities on your phone when the SIM Access Profile connection is active.
You'll be able to make or receive calls from the car kit phone during this time. After
the connection is disconnected, you will be able to use your phone as before.
), tap Advanced.
Bluetooth 191