Starting The Memory; Changing The Signal Duration; Care And Cleaning; Cleaning Agents - Bosch HMT84G651B Instruction Manual

You can save the memory settings and start the appliance
■
immediately. When finishing, instead of pressing
Start.
Saving a new setting in the memory: press the
■
old settings appear. Save the new programme as described
in steps 1-4.

Starting the memory

It is very easy to start the saved programme. Place your meal
into the appliance. Close the appliance door.
Press the button.
f
1.
The saved settings are displayed.
Press the Start button.
2.

Changing the signal duration

You will hear a signal when the appliance is switched off. You
can change the duration of the acoustic signal.
Press the Start button for approx. 6 seconds.

Care and cleaning

With careful care and cleaning your microwave oven will retain
its looks and remain good order. We will explain here how you
should care for and clean your appliance correctly.
ã=
Risk of short circuit!
Never use high-pressure cleaners or steam cleaners to clean
the oven.
ã=
Risk of burns!
Never clean the appliance immediately after switching off. Let
the appliance cool down.
ã=
Risk of electric shock!
Do not immerse the appliance in water or clean under a jet of
water.
Surfaces are different, and damage caused by using the wrong
cleaning agent can be avoided by observing the information in
the table below.
Do not use
sharp or abrasive cleaning agents.
■
The surface could be damaged. If such a substance comes
into contact with the front of the appliance, wash it off
immediately with water.
metal or glass scrapers to clean the glass in the appliance
■
door.
metal or glass scrapers for cleaning the seal.
■
hard scouring pads or cleaning sponges.
■
Wash new sponge cloths thoroughly before use.
cleaning agents with high concentrations of alcohol.
■

Cleaning agents

Caution!
Before cleaning, unplug the appliance from the mains or switch
off the circuit breaker in the fuse box. Clean the outside of the
appliance and the cooking compartment with a damp cloth and
mild detergent. Dry with a clean cloth.
10
The cooking time counts down in the display.
f , press
The cooking time has elapsed
A signal sounds. Open the appliance door or press Stop. The
button. The
f
clock reappears.
Pausing
Press the Stop button once, or open the appliance door. Press
the START button after closing the door.
Cancelling the setting
Press the Stop button twice, or open the appliance door and
press the Stop button once.
The new signal duration is adopted.
The clock reappears.
The following are possible:
Short signal duration - 3 tones
Long signal duration - 30 tones.
Area
Appliance front
Appliance front with
stainless steel
Cooking compart-
ment made of stain-
less steel
Recess in cooking
compartment
Turntable and turnta-
ble ring
Wire rack
Cleaning agents
Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth. Do not use glass cleaners or
metal or glass scrapers for cleaning.
Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth. Remove flecks of limescale,
grease, starch and albumin (e.g. egg
white) immediately. Corrosion can form
under such residues. Special stainless
steel cleaning agents can be obtained
from the after-sales service or from spe-
cialist shops. Do not use glass cleaners
or metal or glass scrapers for cleaning.
Hot soapy water or a vinegar solution:
Clean with a dish cloth and dry with a
soft cloth.
If the oven is very dirty: use oven
cleaner, but only when cooking com-
partment is cold. It is best to use a stain-
less-steel sponge. Do not use oven
spray or other aggressive oven cleaners
or abrasive materials. Scouring pads,
rough sponges and pan cleaners are
also unsuitable. These items scratch the
surface. Allow the interior surfaces to
dry thoroughly.
Damp cloth:
Ensure that no water seeps through the
turntable drive into the appliance inte-
rior.
Hot soapy water:
When putting the turntable back in
place, make sure it slots in correctly.
Hot soapy water:
Clean using stainless steel cleaning
agent or in the dishwasher.