Maintainance - Ei Electronics Carbon Monoxide Alarm Ei 204EN Instructions Manual

B15583/R0/204EN&205EN/U&C 8/6/06 1:54 PM Page 21
How to distinguish between CO Alarm and Smoke Alarm warnings
The CO Alarm has a distinctive on-off sound of 3 pulses, followed by a pause as
compared with a typical Smoke Alarm which has a rapid pulsing sound.
In addition, when your CO Alarm detects CO the red light will be flashing.
Testing both your CO Alarm and Smoke Alarms weekly will help you and your family
to clearly distinguish between them in an emergency.
7. MAINTAINENCE
Clean the outside case by occasionally wiping with a clean damp cloth. Do not use any
cleaning agents, bleaches, detergents or polishes, including those in aerosol cans.
Avoid spraying air fresheners, hair spray, paint or other aerosols near the CO Alarm.
Do not place air fresheners near the unit.
Use the narrow nozzle of a vacuum cleaner to remove fluff and other contamination
from the cover slots to ensure CO gas can reach the sensor - see Gas Sensor
positioning shown in figure 5a.
Caution: Do not paint the CO Alarm.
Remove the CO Alarm when decorating. Do not allow water or dust to contaminate the
alarm.
Warning: Do not open or tamper with the CO Alarm. There are no user serviceable
parts inside This can damage the unit.
21