Download Print this page

Ei Electronics Ei 225E User Instructions

Mains powered carbon monoxide alarms

Advertisement

Quick Links

1.
READ THIS FIRST
4
Open unit by sliding cover up as shown in figure 1. Then
remove the terminal block cover screw.
What to do when the Alarm sounds:
?
(1) Open the doors and windows to ventilate.
(2) Turn off the appliance where possible and stop using
the appliance.
(The alarm can be silenced immediately by
pushing the test/hush button if the level is below 150ppm CO).
(3) Evacuate the property leaving the doors and windows
open.
(4)
Telephone your gas or other fuel supplier on their emer-
gency number; keep the number in a prominent place.
(5) Do not re-enter the property until the alarm has
stopped. (If the alarm has been silenced by pressing the
test/hush button, wait at least 5 minutes so the alarm can
check that the CO has cleared).
(6) Get medical help immediately for anyone suffering the
effects of carbon monoxide poisoning (headache, nau-
sea), and advise that carbon monoxide poisoning is sus-
pected.
(7) Do not use the appliance again until it has been
checked by an expert. In the case of gas appliances this
must be a CORGI registered installer.
?
When the CO Alarm detects abnormal levels of CO
(above 150ppm CO for 30 minutes) the horn sounds and
the red light starts to flash. At higher levels of CO the
alarm will turn on sooner (see table B).
?
The CO Alarm will automatically reset within about 4 min-
utes once the CO has cleared. Pressing the test /hush but-
ton resets the CO Alarm immediately if it has sensed
about 150ppm CO (the unit cannot be silenced if the level
is about 350ppm CO). If CO is still present the red alarm
light and horn will turn on again after 4 minutes.
WARNING: The CO Alarm is no substitute for keeping
!
chimneys and flues clear and in good condition, and all of
your appliances serviced regularly according to the manu-
facturer's instructions.
8
Do not fit alarm until all building work is completed to avoid
contamination.
2
(Cont.)
TERMINAL
BLOCK
COVER
SCREW
2.
Carbon Monoxide - The Silent Killer
2.1 What is Carbon Monoxide ?
Congratulations on becoming the owner of an Ei Carbon Mon-
oxide Alarm. This will help protect you and your household from
the dangerous effects of carbon monoxide - the silent killer (CO
is the chemical symbol).
Many are killed each year, and many more suffer ill health from
carbon monoxide (CO) poisoning. CO is an invisible, odourless,
tasteless and extremely toxic gas. It is produced by appliances
or vehicles burning fuels, such as coal, oil, natural/bottled gas,
paraffin, wood, petrol, diesel, charcoal etc. CO is absorbed by
red blood cells in the lungs in preference to oxygen - this results
in rapid damage to the heart and brain from oxygen starvation.
High levels of CO in a house can be caused by:
Incorrectly or poorly installed fuel-burning appliances.
l
Blocked or cracked chimneys/flues.
l
l
Blocked vents or draught-proofing which makes areas with
fuel burning appliances or fireplaces airtight.
l
Engines of cars, lawnmowers etc. left running in confined
spaces.
l
Portable paraffin or gas heaters in badly ventilated rooms.
2.2 Symptoms of Carbon Monoxide Poisoning
Most people know that high levels of CO are harmful, however
the period of exposure is also important.
The following symptoms are related to carbon monoxide poi-
soning and should be discussed with all members of the house-
hold.
Mild Exposure: Slight headache, nausea, vomiting, fatigue (of-
ten described as "flu-like" symptoms).
Medium Exposure: Severe throbbing headache, drowsiness,
confusion, fast heart rate.
Extreme Exposure:
diorespiratory failure, death.
A high level of CO for a short period (e.g. 350 ppm CO for 30
minutes) will cause the same symptoms, a slight headache, as a
lower level for a longer time (e.g. 150 ppm for 90 minutes). Table
PRESS HERE
A shows how exposure to different concentrations of CO gener-
FIRST AND
ally affects people.
SLIDE UP
Many cases of reported carbon monoxide poisoning indicate
that while victims are aware they are not well, they become so
GAS SENSOR
POSITION
disorientated they are unable to save themselves by either leav-
ing the building or calling for assistance. Young children and
Figure 1
household pets may be the first affected.
Table A: Effects of Cumulative CO Exposure
2.3 What happens when your CO Alarm detects Carbon
When the Alarm detects dangerous levels of CO, it sounds a
loud alarm and flashes the red alarm light.
3
Unconsciousness, convulsions, car-
Concentration of
Inhalation Time (approx)
CO in Air
and Symptoms Developed
ppm s
35
The maximum allowable concentration for continuous
exposure in any 8-hour period according to OSHA *.
150
Slight headache after 1½ hours.
200
Slight headache, fatigue, dizziness, nausea after 2-3
hours.
400
Frontal headaches within 1-2 hours, life threatening
after 3 hours, also maximum parts per million in flue
gas (on an air free basis) according to US Environ-
mental Protection Agency.
800
Dizziness, nausea and convulsions within 45 minutes.
Unconsciousness within 2 hours. Death within 2-3
hours.
1,600
Headache, dizziness and nausea within 20 minutes.
Death within 1 hour.
3,200
Headache, dizziness and nausea within 5-10 minutes.
Death within 25-30 minutes.
6,400
Headache, dizziness and nausea within 1-2
minutes. Death within 10-15 minutes.
12,800
Death within 1-3 minutes.
s
* OSHA Occupational Safety &
ppm = parts per million
Health Association
Monoxide ?
4

Advertisement

loading

Summary of Contents for Ei Electronics Ei 225E

  • Page 1 Medium Exposure: Severe throbbing headache, drowsiness, READ THIS FIRST (Cont.) confusion, fast heart rate. Extreme Exposure: Unconsciousness, convulsions, car- Open unit by sliding cover up as shown in figure 1. Then remove the terminal block cover screw. diorespiratory failure, death. What to do when the Alarm sounds: A high level of CO for a short period (e.g.
  • Page 2: Where To Place Co Alarms

    3.1 Suitable Locations Pre-Alarm contains a fuel-burning appliance. Flashes every 5 sec Ei Electronics recommends that the advice of the Health & Alarm 30 min Safety Exectutive (HSE) UK is followed as this is based on re- Flashes every 2 sec...
  • Page 3 - the alarm should be located at a level similar to the breathing cleaning agents etc. may damage the sensor). Testing your CO Alarm zone of the occupant (typically in the living rooms at 1.5 to 2.0m Procedure: above floor level and in bedrooms at the height of the bed). (1) Regularly check that the green mains power light is on - the 1.
  • Page 4: Limitations Of Co Alarms

    How to distinguish between CO Alarm and Smoke (2) Carbon monoxide must enter the unit for it to be detected. How to Protect your Family There may be carbon monoxide in other areas of the house Alarm warnings (e.g. downstairs, in a closed room etc.) but not in the vicinity Follow these guidelines to reduce the risk of carbon monoxide The CO Alarm has a distinctive on-off sound of 3 pulses, fol- of the CO Alarm.
  • Page 5: Troubleshooting

    At 350 ppm CO, in less than 6 minutes red light flashes every 0.5 seconds and to where it was purchased or alternatively to Ei Electronics , carefully packaged, with the (1) Ensure there are no fuel burning appliances in the vicinity horn sounds.
  • Page 6: Read This First

    CARBON MODEL Ei 225E MONOXIDE ALARM Ref No. B14689 Rev 0 © Ei Electronics 2002 READ THIS FIRST WARNINGS The Alarm should be permanently wired to the mains by a qualified electrician in accordance with IEE wiring regulations. Do not locate the CO Alarm where it could be exposed to dripping, splashing or condensation (e.g.