Table of Contents
Advertisement
B15404-R0-261EN-UC-ENG
31/5/07
The CO Alarm will automatically reset
?
once the CO has cleared. Pressing the
test/hush button resets the CO Alarm
immediately (below 300ppm CO). If CO
is still present the red light and horn will
turn on again after about 4 minutes.
The CO Alarm is no substitute for keep-
?
ing chimneys and flues clear and in
good condition, and all of your appli-
ances serviced regularly according to
the manufacturer's instructions.
Do not fit alarm until all building work
is completed to avoid contamination.
2. CARBON MONOXIDE
- THE SILENT KILLER!
2.1 What is Carbon Monoxide ?
Congratulations on becoming the owner of
an Ei Carbon Monoxide Alarm. This will help
protect you and your household from the
dangerous effects of Carbon Monoxide - the
silent killer. (CO is the chemical symbol, indi-
cating the module has one carbon atom and
one oxygen atom).
2:01 PM
Page 5
WARNING: DISCONNECT MAINS BEFORE REMOVING ALARM FROM
Figure 1 - Alarm Installation
LOCATION FOR
TAMPERPROOF SCREW
(see page 16)
SIDE VIEW
MOUNTING PLATE
TAMPERPROOF CATCH
CEILING OR WALL
3
GAS ENTRY HOLES
PUSH SMALL
SCREWDRIVER
STRAIGHT IN
TO RELEASE.
PUSH COVER
BACK
Advertisement
Table of Contents
