Hunter 23722 Owners And Installation Manual page 16

7 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
7-10. Remove the three lower switch housing screws, then remove the
lower switch housing.
7-11. To uninstall the light fixture, first disconnect the plug
connectors between the black wire and the red wire.
7-12. Disconnect the plug connectors between the two white
wires.
7-13. Remove the two screws attaching the light kit to the
lower switch housing.
7-14. Remove the light fixture from the lower switch housing,
pulling disconnected wires through the hole in the
center of the lower switch housing.
Note: When removing the wires, pull the thin plug
connector (male) through first, and then pull the other
plug connector (female) through the hole.
7-15. Install the dummy terminals (included in the sack parts)
on the two disconnected wires in the lower switch
housing.
7-16. Install the switch housing cap and plug button to the
lower switch housing.
7-17. Once you have uninstalled the light fixture, continue
with Step 7-1.
Plug Button
15
45052-01 • 04/26/10 • Hunter Fan Company
Steps 7-13 – 7-15
Cap
Lower Switch
Housing
Step 7-16