Table of Contents
Advertisement
2-11
Edge cleaning
Special edge groomers are provided on
both sides of the nozzle to remove dirt in
carpet near baseboards and furniture.
Guide either side of nozzle parallel to
edge of carpet or furniture.
Cleaning tools
When using cleaning tools, cleaner han-
dle should be in the upright position
to activate the automatic "brush roll
OFF" and for convenience in moving
the cleaner from one area to another.
2-12
D
Turn cleaner OFF before disconnect-
ing and connecting hose to hose tube
(D).
To use hose, lift hose end as shown.
2-16
K
Attach wand and tools
Attach tool or wand to the hose (K).
Twist wand or tool slightly to tighten or
loosen the connection.
How to clean tools
To clean the hose and the powered
hand tool*, wipe off dirt with a cloth
dampened in a mild detergent. Rinse
with a damp cloth. Do not submerge
powered hand tool in water.
Wash cleaning tools in warm water with
a detergent. Rinse and air dry before
using.
Extra reach hose
(available at additional cost if not includ-
ed with your cleaner)
The extra reach hose provides a 20 foot
reach to allow easier cleaning of stairs
and hard-to-reach high places. To attach
hose to your vacuum cleaner, follow the
instructions below.
2 - 1 3
A
B
Turn cleaner OFF before disconnect-
ing and connecting hose.
Align end of extra reach hose with pro-
jections (A) over slots (B) on end of
attached hose.
2 - 1 4
Slide hose into slots and twist hose to
lock it into place. (To detach hose,
reverse procedure.)
Attach wands or tools to the other end of
hose.
2-17
Stair cleaning
Use the hose and powered hand tool* or
furniture nozzle for stair cleaning.
CAUTION: To prevent the cleaner
from falling, always place it at the bot-
tom of the stairs.
With handle in upright position, clean
from bottom to top.
*Available at additional cost if not
included with your cleaner.
2-15
F
E
H
Select proper tool
E. Dusting brush may be used for
carved furniture, table tops, books,
lamps, lighting fixtures, venetian blinds,
baseboards, shutters, and registers.
F. Furniture nozzle may be used for
upholstered furniture, draperies, mat-
tresses, clothing, automobile interiors,
and carpeted stairs.
*
G. Powered hand tool
may be used
for upholstered furniture, carpeted stairs
and hard-to-reach places.
H. Crevice tool may be used in tight
spaces, corners and along edges in
such places as dresser drawers, uphol-
stered furniture, stairs and baseboards.
I. Crevice wand can be used in tight
spaces, corners and along edges in
such places as dresser drawers, uphol-
stered furniture, stairs, and baseboards.
It can also be used for extra reach with
the dusting brush and/or extension
wand.
J. Wand is used to give extra length to
your hose. Use it with any of the above
tools.
*Available at additional cost if not
included with you cleaner.
2-18
How to attach tool
cover
The tool cover is designed with a "bre a k -
away" feature which allows it to snap free if
it is pushed open too far.
To reattach, align hinges of cover with slots
on sides of tool storage are a .
Push cover down to secure in place.
G
I
J
7
Hide quick links:
Advertisement
Table of Contents
