Nicam (Sv-635X/Sv-631X/Sv-6315X/Sv-6313X Only); Protecting A Recorded Cassette; Recording A Programme Immediately - Samsung SV-2313X Instruction Manual

NICAM (SV-635X/SV-631X/SV-6315X/SV-613X Only)
NICAM programmes are divided into 3 types. NICAM Stereo,
NICAM Mono and Bilingual (transmission in another language).
NICAM programmes are always accompanied by a standard mono
sound broadcast and you can select the desired sound.
OPTIONS
Please refer to page 34.
MENU :SI
DURATA NASTRO :E180
NORMA COLORE :AUTO
1
Press MENU on the remote control.
IPC :SI
16:9 :AUTO
Result:
❿
NICAM :SI
2
Press the corresponding
❿
USCITA: MENU
" ❷
FUNZIONI
3 Press the OK button to select this option.
Result:
4 Press the corresponding
placed in front of the
5 To...
Mono mode
NICAM mode
6
On completion, press MENU twice to exit the menu.
24
The programming menu is displayed.
or ➛, ❿ buttons to select the
,
" ❷!
option.
The FUNZIONI menu is displayed.
or buttons, until the cursor is
" ❷
NICAM option.
Press ➛ or ❿, until...
NO is displayed.
NO : Only set at this position to record the
standard mono sound during a NICAM
broadcast if the stereo sound is
distorted due to inferior reception
conditions.
SI is displayed.
SI : Normally set at this position.

Protecting a Recorded Cassette

Video cassettes have a safety tab to prevent accidental erasure.
When this tab has been removed, you cannot record on the tape.
1 If you wish to protect a cassette, break off the tab using a small
screwdriver.
2 To re-record over a protected cassette (safety tab broken), cover
the hole with adhesive tape.

Recording a Programme Immediately

Before recording a programme, you must have preset the corres-
ponding station (unless you are recording via an external video
source). If you have not done so, refer to pages 18 and 19.
1
Switch on the television.
2 To monitor the programme being recorded, select the television
channel reserved for use with your VCR (or the AV input if used).
3 Insert the cassette on which the programme is to be recorded,
with the window visible and the safety tab intact or the opening
covered with adhesive tape.
Result: The VCR is switched on automatically.
4 Select:
The station to be recorded using the PROG/TRK (" or ❷) /
PROG (" or ❷) buttons
or
The AV1, AV2 or AUX (SV-635X/SV-631X/SV-6315X/
SV-6313X/SV-530X/SV-435X/SV-235X only) source using
the INPUT button for a satellite tuner or external video source
Result: The station number is displayed and the programme
can be seen on the television.
With SV-635X/SV-631X/SV-6315X-SV-6313X/SV-530X/SV-435X/
SV-431X, you can select the recording speed (SP/LP). Press the
SPEED button.
5
Hold REC ( ) down for a while to start recording.
Result: The record indicator appears on the television and VCR
display. An index is recorded on the tape (see page 36).
6 To stop recording, press once.
If the cassette is ejected when you start recording,
check that the safety tab is intact or the opening is
covered with adhesive tape.
If you reach the end of the tape while recording, the
cassette rewinds automatically.
GB
1
(SV-631X/SV-6315X/SV-6313X/
(SV-635X) SV-530X/SV-435X/SV-431X/SV-235X/
SV-231X/ SV-2315X/SV-2313X)
DISP./
DISPLAY
4
4
VOL PROG/TRK
TRK PROG
4
4
5
OK
OK
6
25