Viewing the Connection Panel
Connecting an Aerial or Cable Television Network (depending on the model).
To view television channels correctly, a signal must be received by the set from one of the
following sources:
- An outdoor aerial
- A cable television network
- A satellite network
Connecting Component Device (DVD - 480i, 480p, 576i, and 576p only supported).
- Connect component video cables to component connector ("Y", "P
other ends to corresponding component video out connectors on the DVD.
- The Y, Pb and Pr connectors on your component device (DVD) are sometimes labeled Y, B-Y and R-Y or Y,
Cb and Cr.
- Connect RCA audio cables to "L - AUDIO - R" on the rear of your set and the other ends to corresponding
audio out connectors on the DVD.
- Input signals not supported: 720p, 1080i, and 1080p.
Connecting a Computer.
- Connect the 15 Pin D-SUB connector to the PC video connector.
- Connect the stereo audio cable to the "PC AUDIO IN" jack (
the "Audio Out" jack of the sound card on your computer.
15 Pin D-SUB connector
Pin
Separate H/V
1
Red (R)
2
Green (G)
3
Blue (B)
4
Grounding
5
Grounding (DDC return)
6
Grounding - Red (R)
7
Grounding - Green (G)
8
Grounding - Blue (B)
9
No connection
10
Grounding - Sync. / Self test
11
Grounding
12
DDC - SDA (Data)
13
Horizontal Sync.
14
Vertical Sync.
15
DDC - SCL (Clock)
", "P
") on the rear of your set and the
B
R
) on the rear of your set and the other end to
Composite H/V
Red (R)
Green (G)
Blue (B)
Grounding
Grounding (DDC return)
Grounding - Red (R)
Grounding - Green (G)
Grounding - Blue (B)
No connection
Grounding - Sync. / Self test
Grounding
DDC - SDA (Data)
Horizontal/Vertical Sync.
Not used
DDC - SCL (Clock)