Connecting An S-Vhs Vcr - Samsung CT-21T20MQ Owner's Instructions Manual

AA68-03465A-00Eng_XTC
I
N S TA L L AT I O N

Connecting an S-VHS VCR

(CT29M16MQU/CT25M20MQU/CT29M20MQU)
Your Samsung TV can be connected to an S-Video signal from an S-VHS VCR. (This
connection delivers a better picture as compared to a standard VHS VCR.)
Make sure the jacks you are using are underneath the number "2."
An S-video cable is usually included with an S-VHS VCR. (If not, check your local
electronics store.)
Note: This figure shows the Standard connector-jack panel. The actual configuration for
your TV may be different.
14
5/7/04 1:30 PM Page 14
1
To begin, follow steps
1–3 in the previous
section to connect the
antenna or cable to your
VCR and your TV.
2
Connect a set of audio
cables between the
AUDIO OUT jacks on the
VCR and the 2 AUDIO
INPUT jacks on the TV.
3
Connect an S-video
cable between the
S-VIDEO OUT jack on the
VCR and the
S-VIDEO INPUT
jack on the TV.
VCR Rear Panel
Coaxial Cable
VCR Rear Panel
Audio Cable
VCR Rear Panel
Video Cable
TV Rear Panel
TV Rear Panel
TV Rear Panel