Setting The Speaker Mode; Setting The Test Tone - Samsung HT-DB390 Instruction Manual

Setting the Speaker Mode

Press Cursor
1 2
button to move to
Press MENU button.
'Audio' and then
press ENTER button.
Press Cursor
3 In the Speaker 4 , buttons to move
to the desired
Setup, press the
speaker and then
ENTER button again.
press ENTER button.
•
For C, LS, and RS, each time the button
is pressed, the mode switches
alternately as follows: SMALL
•
For L and R, the mode is set to SMALL.
SMALL : Select this when using the speakers.
NONE : Select this when no speakers are installed.
Note
•
With
mode.
43
, ,
NONE.
(Dolby Pro Logic II), the delay time may be different for each

Setting the Test Tone

1 2
Press MENU button.
Press RETURN button to return to the previous level.
Press MENU button to exit the setup screen.
When manually testing using the TEST TONE button
Press TEST TONE button.
•
Test tone will be produced as follows:
When playing a DVD or CD, this will work
only in Stop mode.
•
Use this function to check that each speaker is
correctly connected and that there is no problem.
To end the test tone,
press TEST TONE button.
Press Cursor Press Cursor
3
button to move to to move to 'TEST
'Audio' and then TONE' and then press
press ENTER button. ENTER button.
•
The test tone will be sent to L
R RS LS
If the button is pressed again at this
time, the test tone will stop.
L: Front Speaker (L) C: Center Speaker
R: Front Speaker (R) LS: Rear Speaker (L)
Multi-Channel Pro Logic Mode
Start
button
C
SW in that order.
SW: Subwoofer
RS: Rear Speaker (R)
44