Table of Contents
Advertisement
Connecting peripheral equipment
Rear connection
Front connections
Tips
Installation
Impossible to call up the INSTALLATION menu?
Poor reception or no picture
Standby
Still no results?
Recycling directive
8
You can connect any equipment that has a euroconnector socket to your TV set
(video recorder, decoder, etc.).
For further information on connecting a video recorder, refer to its user manual.
When the headphones are connected, the sound on the TV set is automatically
a
muted. Press keys
Some models have
AUDIO / VIDEO
There is 1 video input + 1 sound input (mono models) or 2 (
inputs for stereo models. For a mono sound camcorder, connect the audio signal to
the
input. Use the
AUDIO L
loudspeakers of the television.
To select the connected equipment
X
Use the
key on the remote control to select the
(front socket: on certain models).
EXT2
Most equipment (decoder, video recorder) carries out the switching itself.
When a peripheral device provides RGB signals (game, satellite receiver, ...), it has priority
over the TV programmes.The peripheral device has to be switched off if you want to watch
the TV channels. If you wish to avoid this inconvenience, configure the peripheral equipment
to provide composite video signals (CVBS PAL/SECAM) instead of RGB signals (refer to the
peripherasl user manual).
To avoid any dangerous situations and operating faults, do not place anything on the
TV set and leave a space of at least 5 cm around the appliance.
The
function is enabled (refer to page 5).To rapidly unlock all
CHILDLOCK
programmes, call up the
Set the
PROGRAMME
All the programmes are now unlocked.
The proximity of mountains or high buildings may be responsible for ghost pictures,
echoing or shadows. If this is the case, modify the orientation of the outside aerial
and check that the TV channel is tuned in correctly (refer to
Does your antenna enable you to receive broadcasts in this frequency range? Have
you chosen the correct system (page 3)?
Are your aerial and euroconnector sockets correctly connected?
If the peripheral equipment connected to the
To save electricity it is advisable to switch the TV set off using the on/off key on the
front of the set. If the set receives no signal for 15 mins, it automatically switches to
standby mode.
If you have a problem with your TV set, never attempt to repair it yourself: contact
your dealer's after-sales service.
Your TV set uses materials which are reusable or which can be recycled.
To minimise the amount of waste in the environment, specialist companies recover
used sets for dismantling and collection of reusable materials (consult your dealer).
and
to adjust the volume.
connections on the front of the TV set.
f
g
-
key to reproduce the sound on the left and right
menu and enter your confidential code.
CHILDLOCK
item to
Set the
ALL.
) and (
L
(
) (rear socket) or
EXT
1
item to
and then to
LOCK
YES
FINE TUNE
is on switch it off.
EXT1
) sound
R
.
NO
page 3).
Advertisement
Table of Contents
