Table of Contents
Advertisement
10
Dolby Pro Logic
This state of the art Dolby Pro Logic
mini system enables you to experience
and enjoy a Home Cinema sound
ambience. The Pro Logic system allows
more accurate definition of the
individual sound sources. It produces
greater sound separation between
channels and provides pinpoint sound
localization. Pro Logic provides four
sound outputs: Left, Center, Right and
Surround (Rear). Front sounds are
produced from the pair of Left and
Right speakers and a Center speaker.
The surround sound is reproduced by
two speakers placed at the rear of the
listening area. Although the surround
sound is monaural (single-source), a pair
of speakers is necessary to produce the
correct diffused sound.
This Pro Logic decoder enables you to
decode the following modes: Dolby
Surround, Center Phantom, Dolby 3
Stereo or normal Stereo.
Setting up the Dolby Pro
Logic system
You must set up the system properly in
order to enjoy the Home Cinema
sound to the fullest. First, connect the
speakers.
pg 01-28/P88/37-Eng
DOLBY PRO LOGIC
5-Speaker Connection
• Front speakers: Connect the front
speakers.
• Center speaker: Connect the center
speaker.
• Rear (surround) speakers: Connect
either the wired rear surround speakers
or a pair of wireless rear speakers (not
supplied) to the SURROUND OUT
terminals.
CENTER
REAR
SURROUND
FRONT
REAR
FRONT
LEFT
LEFT
REAR
FRONT
RIGHT
RIGHT
Positioning the Speakers
To get the best surround sound effect,
place the speakers as follows.
CENTER
SPEAKER
SUB-
MINI HIFI
FRONT
WOOFER
SYSTEM
FRONT
LEFT
RIGHT
TV
SURROUND
SURROUND
LEFT
10
Front Left and Right Speakers
For the best sound, place the Left and
Right speakers at an angle of
approximately 45 degrees to the
listener. If the speakers' magnetic field
affects the television picture, increase
the distance between the TV and the
speakers.
Center Speaker
For the best sound, place the center
speaker at the same height as the left
and right speakers. Place the center
speaker directly above or beneath the
television.
Rear (surround) Speakers
The surround speakers should be
placed at normal listening ear level or
mounted on the wall at the back of the
room. Most important, experiment
when placing the surround speakers in
order to obtain the best sound.
Test Tone
This feature enables you to adjust the
Front Left, Front Right, Center and
Surround Sound levels of the respective
speakers in Dolby Pro Logic mode.
You must sit at the ideal sitting
position and use the remote control
RIGHT
to perform this operation.
1 Press CD, TUNER, TAPE or AUX
to switch on the system.
2/16/00, 9:13 AM
2 Press TEST TONE.
REPEAT
S
™ A test signal is
DPL
TEST TONE
BA
generated; it will
L
move through the
CENTER
R
Left, Center, Right,
+
and Surround
speakers, in that order.
™ "TEST TONE" followed by
"ADAPT BALANCE, CENTER
AND REAR LEVEL" will be
displayed.
™ The test signal will last for about
90 seconds.
3 Press
DPL TEST TONE
BALANCE
BALANCE
L
R
L to adjust
CENTER
REAR
the sound
-
+
-
+
of the front
left speaker.
™ The display will show
"BAL L +XX".
4 Press BALANCE R to adjust the
sound of the front right speaker.
™ The display will show
"BAL R +XX".
5 Press CENTER + or - to adjust
the sound of the center speaker.
™ The display will show either
"CENT +XX or -XX".
6 Press REAR + or - to adjust the
sound of the surround speakers.
™ The display will show either
"REAR +XX or -XX".
3139 116 19711 (ENG)
Advertisement
Table of Contents
