Panasonic AW-PH300 Operating Instructions Manual page 12

Setting the Cable Compensation Circuit
If the pan/tilt head is connected to the controller with
coaxial cables (5C-2V), the maximum allowable dis-
tance between them is 500 meters. If the cable length
between them is more than 300 meters, however, set
the cable compensation circuit switch to the ON posi-
tion as described below.
• Remove the 4 screws from Control Connector Panel !2
and pull out the panel toward yourself.
• Set the switch on the PCB on the back of the panel to
the ON position.
• Mount Control Connector Panel !2 back and fasten it
with the screws.
ON
OFF
-10-
Changing Others
Changing the Position of Control Connector Panil
The position of Control Connector Panel !2 can be
changed if necessary.
• Remove the blank panel in the position where you
wish to mount Control Connector Panel !2
• Remove the screws from Control Connector Panel
!2 and pull out the panel up front.
• Disconnect all the 6 connectors on the PCB on the
back of the panel.
• Take Control Connector Panel to the desired posi-
tion, and connect the PCB connectors back as
before.
• Fasten Control Connector Panel !2 and the blank
panel with the screws.
Changing the Direction of Control Connector Panel.
The direction of Control Connector Panel !2 can be
changed by 180° if necessary.
• Remove the screws from Control Connector Panel
!2 and pull out the panel up front.
• Turn the panel 180°, and place it back in position.
• Fasten the panel with the screws.
Changing the Direction of Camera Connector Panel
The direction of Camera Connector Panel i can be
changed by 180° if necessary.
• Remove the screws from Camera Connector Panel
i and pull out the panel up front.
.