To Connect Relay Controls; To Connect Tv On/Off Sensors - Kenwood KRF-X9995D Connection And Setup Manual

Digital audio/video receiver

Hide thumbs Also See for KRF-X9995D:

Table of Contents

Chapter Four: Setting Up Multiple Zones

Connecting and Setting Up On/Off Sensors or Relay Controls (for U.K. only), continued

The KRF-X9995D (model for U.K.) supports 2 types of ad-

ditional external controls:

•

A relay control that enables you to operate external re-

lay-control devices (such as the Xantech 590-0 program-

mable controller, via Xantech's 599-00 pulse switching

module).

•

A TV ON/OFF sensor that enables you to use the Perfect

Macro feature (described further in the Users' Guide) to

accurately sense whether the TV is already on or off and

adjust accordingly.

To Connect Relay Controls:

1. Consult the relay control's manual for compatibility in-

formation and installation instructions before connect-

ing it to your new receiver. If you install the control in-

correctly or connect an incompatible control to the re-

ceiver, you may damage the control and your new re-

ceiver.

2. Connect the control cable to the receiver's RELAY CON-

TROL jack. This jack supports a 12V, 20mA signal.

Do not connect multiple 599-00 switching modules to each

other or to the receiver, as this can exceed the maximum

current capacity of the jack and damage your receiver.

1. Connect the sensor to the TV as described in the sensor's

manual.

2. Connect the sensor cable to the receiver's TV ON/ OFF

SENSOR jack. This jack supports a 5V, 10mA signal.

JDS:PSS-TV or NILES:LS-1, APC-2 sensors are compatible

with your new receiver.

Table of Contents