Table of Contents
Advertisement
The above are additional trademarked names appearing in
this manual. All other products named are trademarks of
their respective companies.
iv
Unpack your new receiver carefully and make sure that all the accessories are present:
Remote control unit
Batteries
AA (R6)
(PowerTouch)
ENTER
UP
CONFIRM
DOWN
CONTRAST
ON/STANDBY
REMOTE OFF
If any accessories are missing, or if the receiver is damaged or fails to operate, notify your dealer immediately. If your receiver was shipped to you
directly, notify your shipper immediately. Kenwood recommends that you retain the original carton and packing materials in case you need to
move or ship the receiver in the future.
CHANNEL SPACE / DE-
EMPHASIS Switch
Not present for U.K. and Australia
The CHANNEL SPACE/ DE-EMPHASIS switch on the rear
panel is set to the correct setting that prevails in the area to
which the unit is shipped. However, if the CHANNEL
SPACE/ DE-EMPHASIS setting is not matched to the area
where the unit is to be used; for instance, if you move from
area 1 to area 2 as shown in the table to the right or vice
versa, desired reception of AM/ FM broadcasts is not ex-
pected. In this case, change the CHANNEL SPACE/ DE-
EMPHASIS setting in accordance with the area correspond-
ing to the table. The CHANNEL SPACE/ DE-EMPHASIS is
switched over at the same time.
•
When changing the setting of the CHANNEL SPACE/
DE-EMPHASIS switch, first unplug the power cord, and
then reset the switch, plug the power cord back in, and
turn the power switch on.
AM Loop Antenna
6
Unpacking
FM Antenna
CHANNEL
Area
SPACE freq.
USA, Canada,
FM : 100 kHz
and South
1
AM : 10 kHz
American
Countries
Other
FM : 50 kHz
2
Countries
AM :
9 kHz
CHANNEL SPACE
DE-EMPHASIS switch
AM
GND
ANTENNA
AC plug adapter
Use to adapt the plug on the power
cord to the shape of the wall outlet.
(Present only for regions where use
is necessary.)
DE-
EMPHASIS
75 s
50 s
75 s
50 s
AM 10kHz
AM 9kHz
FM 100kHz
FM 50kHz
DE-EMPHASIS
CHANNEL SPACE
Advertisement
Table of Contents
