Installation - Kenwood KRC-669 Instruction Manual

Installation

■ Installing in Japanese-Made Cars
1
Refer to the section <Removing the hard rubber frame> (page
27) and then remove the hard rubber frame.
2
Align the holes in the unit (two locations on each side) with
the vehicle mounting bracket and secure the unit with the
accessory screws.
N
T
N
T/N
T
T: Toyota cars
N: Nissan cars
• During installation, do not use any screws except for those provided.
The use of different screws might result in damage to the main unit.
• Damage may occur if a screwdriver or similar tool is used with
excessive force during the installations.
■ Screwing the Faceplate on the Unit
If you want to fasten the faceplate to the main unit so that it
does not fall off.
1
Refer to the section <Removing the hard rubber frame> (page
27) and then remove the hard rubber frame.
2
Drop open the faceplate by pressing the Release button.
8 mm
8mm
MAX.
MAX.
3
4
ø5mm
ø5mm
Accessory3...for Nissan car
Accessory4 ...for Toyota car
— 26 — — 26 —
Tighten the screw (ø2.6 × 12 mm) (Accessory
3
shown on the diagram.
Tighten the screw (ø2 × 4 mm) (Accessory
4
shown on the diagram.
5 Tighten the screws (ø2 × 6 mm) (Accessory
shown on the diagram.
Never insert the screws in any other screw hole than the one specified.
If you screw them in another hole, it will contact and may cause
damage to the mechanical parts inside the unit.
) in the hole
5
Accessory5
) in the hole
6
Accessory6
7 ) in the holes
Accessory7