Honeywell RTH5100B Installation Instructions Manual page 24

Configure Installer Setup (Cont)
6. If you do not have a number 2 on the left side of
your display, go to the next page.
7. If you have a number 2 on the left side of your
display, press the Up or Down button to select your
setting for Installer Setup Number 2 in table below.
8. After you select your setting, press the Next button
to go the next Installer Setup Number.
INSTALLER SETUP
NUMBER
2
69-1716
Replace Batt
Service Needed
Done Next
Heat
Pump
Change-
over
Valve
SETTING
UP BUTTON
DOWN BUTTON
NEXT BUTTON
Use this setting if you connected a
wire labeled O to O/B W terminal.
Use this setting if you connected a
wire labeled B to O/B W terminal.
24
M22060