Table of Contents
Advertisement
Configuring Your Computer
Prior to accessing the router through the LAN or the USB port, note the following necessary
configurations—
•
Your PC's TCP/IP address: 192.168.1.__( the last number is any number between 2 and
254)
•
The router's default IP address: 192.168.1.1
•
Subnet mask: 255.255.255.0
Below are the procedures for configuring your computer. Follow the instructions for the operating
system that you are using.
If you used the Ethernet cable to connect your router and PC, you do not need any specific driver
installation.
Windows 2000
1.
In the Windows taskbar, click the Start button and point to Settings, Control Panel, and
Network and Dial-up Connections (in that order).
2.
Click Local Area Connection. When you have the Local Area Connection Status window
open, click Properties.
3.
Listed in the window are the installed network components. If the list includes Internet
Protocol (TCP/IP), then the protocol has already been enabled, and you can skip to Step
10.
4.
If Internet Protocol (TCP/IP) does not appear as an installed component, then click Install.
5.
In the Select Network Component Type window, click on protocol and then the Add
button.
6.
Select Internet Protocol (TCP/IP) from the list and then click on OK.
7.
If prompted to restart your computer with the new settings, click OK.
8.
After your computer restarts, click the Network and Dial-up Connections icon again, and
right click on the Local Area Connection icon and then select Properties.
9.
In the Local Area Connection Properties dialog box, select Internet Protocol (TCP/IP)
and then click Properties.
10.
In the Internet Protocol (TCP/IP) Properties dialog box, click the radio button labelled Use
the following IP address and type 192.168.1.x (where x is any number between 2 and 254)
and 255.255.255.0 in the IP address field and Subnet Mask field.
11.
Click OK twice to save your changes and then close the Control Panel.
6219-X1 Router Users Guide
21
Advertisement
Table of Contents
