Dell PowerEdge 4300 Installation Instructions Manual page 9

flat tab

     )  &*(
5. Press the back of the clip firmly against the computer's back panel.
6. Affix the second clip above or below the other clip.
Allow 24 hours for the clips to set before attaching the cables.
7 . Turn off the computer.
8. Pull down the grooved tab and insert the cable into the clip.
9. Push the grooved tab under the flat tab until the clip locks securely in place.
10. Repeat steps 8 and 9 for the second cable.
11. Turn on the computer.
         
If your kit includes a SCSI strain-relief bracket, perform the following steps to install
the bracket:
1. Connect the SCSI interface cable(s) to the SCSI host adapter card.
Secure the cable(s) using the two thumbscrews on the cable connector(s).
SMB Connector and SCSI Cable Strain-Relief Kit Installation Instructions
grooved tab
7