Dell PowerEdge 4300 Installation Instructions Manual page 7

9. Reinstall the support panel.
If you installed the GSO-slot SMB connector, route the connector and cable
through the cutout in the support panel (see Figure 5). Ensure that the connector
and cable are positioned properly so that they do not bind between the rubber
standoffs.
support panel
cutout
thumbscrews (2)
support panel

% &     ' ((  
10. Replace the computer cover.
You are now ready to connect the external SMB cable from the SDS 100 storage sys-
tem. For more information on connecting the storage system to a host computer, see
Chapter 2 of the Dell PowerEdge SDS 100 Storage System Installation and Service
Guide.
SMB Connector and SCSI Cable Strain-Relief Kit Installation Instructions
SMB
connector
5