Removing The System From The Rack - Dell PowerEdge 2950 Installation Manual

Figure 1-7. Installing the System in the Rack
1 slide-release latch
4 front release latch

Removing the System From the Rack

To remove the system from the rack, perform the following procedure:
1 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2 Remove the I/O cable connectors and power cable connectors from their respective connectors
on the system back panel.
3 Loosen the thumbscrews on each side of the front chassis panel that secures the system to the rack.
16
Rack Installation Guide
4
2 shoulder screws (6)
1
2
3
3 J slots (6)