Installing The Optional 1X2 Flex Bay Bracket - Dell PowerEdge 2900 Manual

Installing the Optional 1x2 Flex Bay Bracket

NOTE:
The rack front panel is keyed so that the 1x2 flex bay bracket installs in the opposite orientation as the
tower front panel.
1 Insert the 1x2 flex bay bracket three-quarters of the way into the peripheral bay.
2 Reconnect the power cable to the flex bay backplane. See Figure 1-8.
3 Reconnect the SAS cables to the connectors on the flex bay backplane. See Figure 1-8.
4 Push the flex bay bracket the rest of the way into the peripheral bay until the spring latch on top of the
peripheral bay engages.
Figure 1-8. Installing the Optional 1x2 Flex Bay Bracket
7
1 peripheral bay spring latch
4 power connector
7 flex bay
5
6
2 SAS cable (SAS_B_IN
connector)
5 1x2 flex bay drive bracket
1
2
3
3 SAS cable (SAS_B_OUT
connector)
6 slot key
Tower-to-Rack Conversion Guide
4
19