Resetting The Lamp Timer Of The Projector Via Lan - Sharp XG-SV200X Setup Manual

Resetting the Lamp Timer of the Projector via LAN

When the projector is connected to a network, you can use the communications program
to send a command to reset the lamp timer. The example below uses Windows
operating system. When you use Windows Vista
referring to the following steps, because Windows Vista
HyperTerminal.
1 1
Click "Start" – "All Programs" –
"Accessories" – "Communica-
tions" – "HyperTerminal".
• If you do not have HyperTerminal installed,
see the operation manual of your computer.
• Depending on the settings of your computer,
you may be required to enter your area code
and other details. Enter the information as
required.
2 2
Enter a name in the "Name" fi eld,
and click "OK".
3 3
If you are required to enter the
area code, enter it in the "Area
code" fi eld. From the "Connect
using" drop-down menu, select
"TCP/IP (Winsock)", and click
"OK".
4 4
Enter the IP address of the
projector in the "Host address"
fi eld (see "TCP/IP" on the
"Network" menu of the projector),
and enter the data port of the
projector in the "Port number"
fi eld ("10002" is the factory default
setting), and click "OK".
-22
®
, use other communications program
® does not come with
® XP as the
Select Select
"TCP/IP (Winsock)" "TCP/IP (Winsock)"