Resetting The Lamp Timer Of The Projector Via Lan - Sharp PG-F320W Setup Manual

Resetting the Lamp Timer of the Projector via LAN

When the projector is connected to a network, you can use HyperTerminal or a similar com-
munications program to send a command to reset the lamp timer. The example below uses
®
Windows XP as the operating system.
1
Click "Start" – "All Programs" –
"Accessories" – "Communica-
tions" – "HyperTerminal".
• If you do not have HyperTerminal in-
stalled, see the operation manual of your
computer.
• Depending on the settings of your com-
puter, you may be required to enter your
area code and other details. Enter the
information as required.
2
Enter a name in the "Name" field,
and click "OK".
3
If you are required to enter the
area code, enter it in the "Area
code" field. From the "Connect
using" drop-down menu, select
"TCP/IP (Winsock)", and click
"OK".
4
Enter the IP address of the pro-
jector in the "Host address" field
(see "TCP/IP" on the "Network"
menu of the projector), and en-
ter the data port of the projector
in the "Port number" field
("10002" is the factory default
setting), and click "OK".
-30
Select
"TCP/IP (Winsock)"