Adjusting The Projected Image; Adjusting The Projection Angle; Correcting Picture Distortion - BenQ W6000 - DLP Projector - HD 1080p User Manual

Adjusting the projected image

Adjusting the projection angle

There are four adjuster feet on the bottom of the projector. These can be
used if necessary to change the projection angle. Screw the feet in or out as
appropriate to aim and level the projection angle.
If the screen and the projector are not perpendicular to each other, the projected image becomes vertical
trapezoidal. To correct this problem, see

Correcting picture distortion

Keystoning occurs when the projector is not perpendicular to the screen and is where the projected picture
displays visible as a trapezoid shape like either of the following:
• Two parallel sides (left and right, or top and bottom) but is noticeably wider on either side.
• No parallel sides.
To correct the picture's shape, you can perform the following steps.
1. Adjust the projection angle. Move the projector to be in front of the center of the screen with the center
of the lens level with the screen.
2. If the picture is stilled distorted, or the projector is unable to be positioned as described above, you will
need to manually correct the picture.
• Using the remote control or projector
i. Press one of the Arrow/Keystone keys on the remote control or
projector (Left
display the Keystone page.
ii. See step iv below for further operation.
• Using the OSD menu
i. Press MENU and then press
highlighted.
ii. Press to highlight Keystone and press ENTER. The Keystone
page displays.
iii. Highlight 2D Keystone and press ENTER. The keystone
correction page displays.
iv. Press the key whose keystone icon is opposite to the shape of the
projected picture. Continue pressing the same key or press the
other keys until you are satisfied with the shape.
The values on the lower portion of the page change while
pressing. When the values reach their maximum or minimum
with repeated key presses, the picture's shape will stop changing.
You will not be able to change the picture further in that
direction.
Two parallel sides
Press
No parallel sides
Press
"Correcting picture distortion" on page 25
/ , Up / , Right / , Down / ) to
/ until the Display menu is
Press
/
.
Press
/
/
.
Keystone
/
.
.
for details.
Display
Aspect Ratio Anamorphic
Keystone ENTER
Position
Overscan Adjustment 0
PIP
PC & Component YPbPr Tuning
EXIT Back
S-Video
Keystone
2D Keystone ENTER
EXIT
1 0
EXIT Back
Using the projector
Back
25