Using The Projector; Turning The Projector On - BenQ W6000 - DLP Projector - HD 1080p User Manual

Using the projector

Preparations
1. Plug in and turn all of the connected equipment on.
2. If not already in, plug the supplied power cable into the AC inlet
on the rear of the projector.
3. Plug the power cable into a wall power outlet and turn the wall
switch on.

Turning the projector on

Follow the steps below.
1. Make sure the Power light is orange after power has been applied.
2. Press and hold POWER ON ( ) on the projector or remote control
to turn the projector on.
3. The fans will start operating, and a start-up image displays on the
screen for a few seconds while it warms up.
The projector will not respond to further commands while it is
warming up.
4. If you are prompted for a password, press the arrow keys to enter a six-digit password. See
password function" on page 23
5. "Source Searching..." will be displayed on the screen before the projector identifies the input source.
This message will remain on the screen until a valid signal is detected. See
on page 21 for details.
6. If the horizontal frequency of the input source exceeds the range of the projector, the message "No
Signal" will be displayed on the screen. This message will remain on-screen until you change the input
source to an appropriate one.
20 Using the projector
I
I
for details.
"Utilizing the
"Selecting an input source"