Edelbrock 1403-1413 Owner's Manual page 22

1403-1413 Perf Series Carburetor Owner's Manual.qxd
#1406 Calibration Reference Chart / Primary Metering
3 stages
Lean (12%)
3 stages
15
Rich (12%)
2 stages
Rich (8%)
20
1 stage
Rich (4%)
Base
Power
Mode
6
1 stage
Lean (4%)
2 stages
10
Lean (8%)
3 stages
11
Lean (12%)
Lean
1
Stock Calibration
Numbers in black are the steps obtainable using Calibration Kit #1487 plus
#
the stock jets and metering rods.
Numbers in white are the steps obtainable using jet and rod combinations
#
shown on the following page.
Step 1 Select the combination of Cruise Mode and Power Mode fuel-metering stages
desired for your calibration. Normal calibration changes will be within the gridded
diagonal area. That is, Cruise and Power mode changes should be in the same
direction (either richer or leaner) and usually by the same amount.
Step 2 Find the number that is nearest your desired combination. This is your Calibration
Reference Number.
Step 3 Go to the next page. Find the Calibration Reference Number you have just selected
in Step 2. Listed will be the Main Jet and Metering Rod required to achieve the
desired fuel metering for the Primaries.
Power Mode: Low Vacuum/High Power-Rod Up
Base
2 stages 1 stage Power
Lean (8%) Lean (4%) Mode
17
16
22
21
24
4 5
1
8
7
12 13
Power Mode
22
Edelbrock Performer Series Carburetor Owner's Manual 1/01
3/31/2006 12:04 PM
1 stage 2 stages 3 stages
Rich (4%) Rich (8%) Rich (12%)
18
1
19
23
25
2
2 3
9
14
Rich
Page 22