Frigidaire FGEW2765KB - Gallery 27" Convection Single Oven Specifications page 5

(excludes side swing wall oven)
Side filler panels necessary to isolate oven from
adjoining cabinets. Panel height may need to
be modified to accommodate depth of approved
electric cooktop models
Electric Single Wall Oven Cutout
For all 30"& 27"models
cutout depth
4-1/2" maximum height allowed
from oven base to floor if cooktop
is installed directly over wall oven.
(5" maximum height allowed
with no cooktop.)
30"/ 27" Electric Single Wall Oven
Under-Counter Installation Specifications
• Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz
AC only electrical supply with ground required on separate circuit
fused on both sides of line.
• For detailed electrical requirements, refer to model-specific product
page and installation guide on web.
• Always consult local and national electric codes.
• Minimum 21" clearance for oven door depth when open.
Minimum 23-1/2" deep cutout dimension is critical for proper
•
installation, to ensure that oven's faceplate will fit flush against
cabinet front.
• Side filler panels necessary to isolate oven from adjoining cabinets.
• Full oven base of solid plywood or similar material required, capable
of supporting 200 Lbs. (30" models) or 150 Lbs. (27" models).
Install over two runners and flush with toe plate.
• Base must be level and cabinet front must be square.
Allow 5" maximum height from oven base to floor, if NO cooktop is
•
installed directly over wall oven.
USA 10200 David Taylor Drive Charlotte, NC 28262
• •
CANADA 5855 Terry Fox Way
• •
EC_EW INST FR 02/11
Over 30"/27" Electric Single Wall Oven
For all approved electric cooktop models,
cut minimum 4" x 4" opening in right side filler
panel, to route armored cable to junction box
†
Approx. 3"
Plywood
base
240 /208V
Junction box
for wall oven
24" min.
1-800-FRIGIDAIRE
•
Mississauga, ON L5V 3E4 1-800-265-8352
•
Electric Cooktop Installation
Cooktop
Approx. 3"
cutout**
23 /
1
2
min.*
A
Install / " full plywood base on 2 runners, flush with
3
4
toe plate, capable of supporting 200 lbs.
Unit will overlap cutout (minimum) edges by 1"
To route armored cable to junction box,
cut minimum 9" x 9" opening in wood base,
2" from left side filler panel.
Electric Cooktop Installation Over
30"/ 27" Electric Single Wall Oven Specifications
All Frigidaire® Electric Single Wall Ovens are approved to be used
beneath any approved Frigidaire® Electric Cooktop. (This installation
page excludes approved wall oven model GLEB27Z7H. For model-
specific installation details, refer to Electric Cooktop Installation Over
27" Electric Single Wall Oven GLEB27Z7H Specifications pages on web.)
For detailed Electric Cooktop installation, refer to model-specific
product page and installation guide on web.
• Side filler panel height may need to be modified to accommodate the
depth of approved electric cooktop models.
To route armored cable to junction box, cut minimum 4" x 4" opening
•
in right side filler panel.
• Allow 4-1/2" maximum height from oven base to floor, if cooktop is
installed directly over wall oven.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
frigidaire.com
•
frigidaire.ca
•
© 2011 Electrolux Home Products, Inc.
240/208V
Junction box
for electric
cooktop
Oven cutout
36"
min.
27 / "min.
1
4
28 / " max.
5
8
Cutout Width ( A )
30" Wall 28 / " min.
1
2
Oven 29" max.
27" Wall 24 / " min.
7
8
Oven 25 / " max.
1
4
Specifications
subject to change.
Printed in the U.S.A.