Cisco WS-SUP720-3B - Supervisor Engine 720 User Manual page 30

RSP720 with 10GE Uplink Ports
Note
• SPA interface processors (SIPs) and their shared port adapters (SPAs): 7600-SIP-600,
7600-SIP-400, and 7600-SIP-200
• Enhanced FlexWAN module (WS-X6582-2PA)
• Ethernet services modules: 2-port 10 GE line card (7600-ESM-2X10GE) and 20-port 1 GE line card
(7600-ESM-20X1GE)
Distributed Forwarding Cards: DFC3C, DFC3CXL, DFC3B, DFC3BXL
•
• LAN cards (which require CFC or DFC):
–
–
–
–
–
Uplink port transceiver modules: see
•
Note
Unsupported Chassis and Modules
The RSP720-10GE does not support the following chassis and modules:
• Unsupported chassis: Cisco 7603, 7606, and 7613 chassis
Unsupported modules: Services modules, Optical Service Modules (OSMs), FlexWAN module
•
Unsupported Features
In Cisco IOS Release 12.2SRC, the RSP720-10GE does not support the following features, which are
supported on the RSP720:
High-availability features such as NonStop Forwarding with Stateful Switchover (NSF/SSO) and
•
In-Service Software Upgrade (ISSU) are not supported. Only Route Processor Redundancy (RPR)
mode is supported.
For SRD4 release, two new commands are introduced for high availability feature. The commands are
Note
platform redundancy bias and show platform redundancy bias.
For complete syntax and usage information for the commands, refer to the Cisco IOS High Availability
Command Reference at this URL:
http://www.cisco.com/en/US/docs/ios/ha/command/reference/ha_book.html
The uplinks on the standby RSP720-10GE are not active. This restriction exists because the uplink
•
ports must perform lookups on the active RSP, which is not possible in RPR mode.
Intelligent Service Gateway is not supported.
•
Device authentication to prevent counterfeiting
•
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
2-12
If you insert an RSP720-10GE into an unsupported chassis, the RSP720-10GE drops to
ROMmon and only the console is accessible.
WS-X67xx
WS-X65xx
WS-X64xx
WS-X63xx
WS-X61xx
The RSP720-10GE also supports two new 8-port 10GE line cards (WS-X6708-10G-3C and
WS-X6708-10G-3CXL). The line cards, which provide 2-to-1 oversubscription, are
available in Cisco IOS Release 12.2SRC and later.
Chapter 2 Route Switch Processors and Supervisor Engines
Appendix B, "Cable and Connector Specifications"
OL-10100-11