Document Organization; Document History - Cisco WS-SUP720-3B - Supervisor Engine 720 User Manual

Table 1
Revision
OL-10100-08
OL-10100-07
OL-10100-06
OL-10100-05
OL-10100-04
OL-10100-03
OL-10100-02
OL-10100-01

Document Organization

This document is organized as follows:
Chapter
Chapter 1
Chapter 2
Chapter 3
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
viii
Document History (continued)
Date Change Summary
April 2010 Added information about the following supported wavelenghths:
•
•
•
February 2010 Added information about the following command:
•
•
November 2009 Added information about X2-DWDM and X2-10GB-LRM/ZR
support on 7600 cards (RSP720-10GE and WS-X6708-10GE).
March 2009 Added information about increasing RSP720 and RSP720-10GE
maximum switch processor (SP) memory to 2 GB.
January 2008 Added information about the Route Switch Processor 720 with
10-GE uplink ports, introduced in Cisco IOS Release 12.2SRC.
May 2007 Removed eFSU from the list of unsupported features for the
Route Switch Processor 720. Beginning in Cisco IOS Release
12.2SRB1, eFSU and ISSU are supported on the RSP720,
Sup720, and Sup32.
Added a note that Cisco IOS Release 12.2SXF is the last release
in which the Supervisor Engine 720 (with PFC3A) is supported.
February 2007 Added information about the Route Switch Processor 720 (a new
supervisor engine) introduced in Cisco IOS Release 12.2SRB.
May 2006 Initial release of the document.
Title
Cisco 7600 Product
Overview
Route Switch Processors
and Supervisor Engines
Installing and Configuring
Route Switch Processors
and Supervisor Engines
DWDM-SFP-xxxx 40x wavelengths on RSP720
CWDM-SFP-xxxx on RSP720 GE
DWDM-SFP-xxxx on SUP32 and 67xx-SFP on c7600 (8x
additional wavelengths)
show platform redundancy bias and platform redundancy bias
mls qos recirc untrust
Description
Provides an overview of Cisco 7600 series routers, and
interface and port addresses.
Describes the route switch processors (RSPs) and
supervisor engines supported on Cisco 7600 series
routers.
Provides instructions for installing and removing RSPs
and supervisor engines and connecting to the console
and uplink ports.
Preface
OL-10100-11