Intel Desktop Board DP55WB Product Guide
Main Memory
NOTE
To be fully compliant with all applicable Intel
board should be populated with DIMMs that support the Serial Presence Detect (SPD)
data structure. If your memory modules do not support SPD, you will see a
notification to this effect on the screen at power up. The BIOS will attempt to
configure the memory controller for normal operation.
The Desktop Board supports the following memory:
•
Four 240-pin Double Data Rate 3 (DDR3) SDRAM Dual Inline Memory Module
(DIMM) connectors with gold-plated contacts arranged in two channels
•
1333/1066 MHz DDR3 SDRAM interface
•
Support for single- and dual-channel memory interleaving
•
Unbuffered, non-registered single- or double-sided DIMMs with a voltage rating of
less than 1.6 V
NOTE
Using a DIMM with a voltage rating higher than 1.6 V may damage the processor.
•
Non-ECC DDR3 memory
•
Serial Presence Detect (SPD) memory only
•
Up to 16 GB maximum total system memory
NOTE
32-bit operating systems are limited to a maximum of 4 GB of memory. These
operating systems will report less than 4 GB because of the memory used by
add-in graphics cards and other system resources.
14
®
SDRAM memory specifications, the