Eclipse CD8053 Owner's Manual page 84

How to operate the Sound Adjustment Mode
CROSSOVER ADJUSTMENT (X-Over)
The frequencies for the front and rear speaker high-pass filter
(HPF) and woofer low-pass filter (LPF) can be set within a
range of 63 to 200 Hz. (This is the same as the HPF and LPF
cutoff frequencies.)
Turn the [SEL] button to select X-Over.
1
The selected item will be highlighted.
Press the [SEL] button.
2
The mode will change to crossover setting mode.
Turn the [SEL] button to select the cut-off frequency.
3
When the button is turned, the frequency changes in the
following order.
63Hz ↔ 80Hz ↔ 100Hz ↔ 125Hz ↔ 160Hz ↔ 200Hz ↔
4
Press the [SEEK
[SEEK
[FAST
If no woofer has been connected, set the slope adjustment to
"PASS". (If you set the slope to 12 dB/oct, the bass sound will not
ATTENTION
be output from the speakers.
5 Press the [RTN] button.
At this time, other adjustments can also be made in normal
mode.
Press the [SOUND] button for less than one second to
6
exit sound adjustment mode.
/FAST
] button: PASS
] button: 12dB/oct
84
[SOUND] button
[SEEK
[RTN] button
[FAST
] buttons to set the slope.
] button
[SEL]
button
] button