Connectors - Intel BLKD865GBF Specification

Intel Desktop Board D865GBF/D865GLC Technical Product Specification

2.8 Connectors

CAUTION
Only the following connectors have overcurrent protection: Back panel and front panel USB,
PS/2, and VGA.
The other internal connectors are not overcurrent protected and should connect only to devices
inside the computer's chassis, such as fans and internal peripherals. Do not use these connectors
to power devices external to the computer's chassis. A fault in the load presented by the external
devices could cause damage to the computer, the power cable, and the external devices themselves.
This section describes the board's connectors. The connectors can be divided into these groups:
Back panel I/O connectors (see page 69)
PS/2 keyboard and mouse
USB (four ports)
Parallel port
Serial port A
VGA port
LAN
Audio (line out, line in, and mic in)
Internal I/O connectors (see page 70)
Audio (auxiliary line input, ATAPI CD-ROM, and front panel audio)
Fans [three]
Power
Add-in boards (PCI and AGP)
Parallel ATA IDE
Diskette drive
SCSI hard drive activity LED (optional)
Chassis intrusion
Serial ATA
External I/O connectors (see page 79)
Front panel USB (two connector for four ports)
Auxiliary front panel power/sleep/message-waiting LED
Front panel (power/sleep/message-waiting LED, power switch, hard drive activity LED,
reset switch, and auxiliary front panel power LED)
NOTE
When installing the D865GLC board in a microATX chassis, make sure that peripheral devices are
installed at least 1.5 inches above the main power connector, the diskette drive connector, the
Parallel ATA IDE connectors, and the DIMM sockets.
68